
Many power banks briefly cut their output, or stop powering anything, when you plug a charger into them. Your Stratux loses power for a moment and reboots, which looks like a receiver fault. Fix it with a bank that says it supports pass-through charging, and test it on the ground before you rely on it.
What is happening
The receiver is fine. The bank is dropping its output. Stratux runs from whatever the bank gives it. Many banks briefly cut their output when a charger goes in, or stop powering anything while they charge. The receiver restarts, and your EFB loses the Wi-Fi network until it’s back up.
We see this in our own support history. In our old mailbox, about 45 threads were battery or charging problems, and around 10 of them were this exact case. Pass-through support also varies from one pack to the next. The stratux.com power guide covers the same advice.
Test it on the ground in two minutes
This test shows how your bank and charger behave together on the ground. It doesn’t prove what happens in flight.
- Charge the bank at least part way. Power the Stratux from it, and wait for the solid green light. That means it’s running.
- Plug your charger into the bank while the receiver is running.
- Watch the LED and your EFB for a full minute. Then unplug the charger and watch again. Some banks drop out on unplugging too.
- If the lights restart or your EFB drops the network at either step, the bank failed this test with this charger. Charge it before you fly, and leave the charger out in flight. Some banks don’t pass power through with a charger below a minimum wattage (Anker example).
Do the test at your desk, not on the ramp. A reboot on the ground costs you a minute. In the air it costs you your traffic and weather.
Things that look the same, and aren’t
Check these before you blame the bank. Each one can make a Stratux restart or look dead.
- A flat or half-charged bank. A new bank may arrive part-charged. A flat bank looks like a dead Stratux, so charge it fully and check the bank’s own lights first.
- A weak cable. Cheap power cables are the most common point of failure, and most power problems trace back to a poor, worn or bent USB cable. Swap the cable before you swap anything else.
- Too little output. A Stratux needs a source that delivers at least 2 A. A flashing red LED means undervoltage. Our power bank guide covers sizes, the USB-A port and the red-LED check.
- The wrong port. Check the rating printed on each port, and use one that delivers 2 A at 5 V. You won’t get more than 5 V from a USB-C port unless a device negotiates it over USB Power Delivery.
If a restart pattern doesn’t fit any of these, work through Stratux troubleshooting: WiFi, GPS and no traffic.
What to do in flight
Charge before you leave. Treat the charger as a ground tool. Even a bank that passed the ground test isn’t worth relying on in flight. Charge it on the ground. Start with a full bank. Size it for the flight with the formula in the power bank guide, and leave a margin.
Who this is not for
This page can’t tell you which banks support pass-through. We don’t have a tested list, and a bank’s spec sheet can change between batches. If the maker’s spec doesn’t say “pass-through,” assume it doesn’t, and use the ground test above.
Frequently asked questions
Can I charge a power bank while it powers my Stratux?
Only if the bank supports pass-through charging. Many banks cut their output when a charger goes in, and the Stratux reboots. Test on the ground first.
Why did my Stratux restart when I plugged the charger into the bank?
The bank most likely cut its output when the charger went in. The receiver lost power and restarted. That points at the bank, not the receiver.
How do I know my bank supports pass-through?
Look for the words “pass-through charging” in the maker’s spec, then run the two-minute ground test. If it restarts, the bank failed with that charger. A higher-wattage charger might change that, but you’d need to test it.
Is a restart the same as undervoltage?
Not always. A flashing red LED means undervoltage. A restart exactly when you plug in the charger points at the bank’s pass-through behavior.
Next step
Power your Stratux from the bank at your desk, plug in the charger, and watch for a restart. If it restarts with that charger, mark the bank “failed pass-through test”. Shopping for a receiver? The Stratux receiver page lists what’s in the box.
